3D printer stories

Saturday, February 2, 2013

Replicator2 air printing again

And costing me lots of expensive filament.
I further tightened the extruder plunger.
This didn't seem to help.

Posted by Digital Scribbles at 8:07 PM
Email ThisBlogThis!Share to XShare to FacebookShare to Pinterest

No comments:

Post a Comment

Newer Post Older Post Home
Subscribe to: Post Comments (Atom)

Blog Archive

  • ▼  2013 (24)
    • ►  March (7)
    • ▼  February (11)
      • Rerouted x-axis stepper motor ribbon cable
      • Replicator2 - heater bad
      • Replicator2 - dead X-axis cable - again
      • some good prints I made for work
      • Replicator2 finally working well - increased temp
      • Replicator2 Extruder upgrade
      • Replicator2 - implementing WingCommanders Mk8 upgrade
      • R2 test box
      • Replicator2 air printing again
      • Replicator2 filament cleaner
      • Intermittent strands - bad Makerbot yellow filamen...
    • ►  January (6)
  • ►  2012 (33)
    • ►  December (33)

About Me

Digital Scribbles
View my complete profile
Simple theme. Powered by Blogger.